1- IFIS page (Integrated Flight Information System)
The IFIS page features artificial horizon and flight data on the left side, while on the right side you have a shot on the the essential engine parameters.
2- PFD page (Primary Flight Display)
The PFD page has a full page attitude indicator that enhances all the flight data in a single screen.
3- EIS page (Engine information System)
The Eis page is composed by all the engine parameters, the hour meters section and the fuel management section.
Eclipse IFIS is available in two versions:
- Engines with carburator.
- Rotax Engines with injection.
ENGINE FUNCTIONS:
- Oil pressure
- Oil temperature
- 6 CHT inputs
- 6 EGT inputs
- Fuel pressure
- Voltmeter
- Tachometer
- Hour-meter, divided also by time in green, yellow and red zones.
- Peak RPM memories (last flight RPM peak and max RPM ever)
- MAP with integrated sensor
- OAT (Outside air temperature)
- CAT (Carburetor/airbox air temperature)
- Battery current
FUEL MANAGEMENT FUNCTIONS:
- Fuel computer (fuel flow, endurance, remaining fuel, burned fuel, range and reserve at destination). It's possible to activate 3 alarms for the remaining fuel, time to empty and for balancing tanks.
When a measure drops below its setpoint the alarm is activated on both display and/or audio out tone or vocal alert
3 fuel level sender inputs with tanks shape correction.
FLIGHT DATA:
- Artificial horizon
- Airspeed tape
- Altitude tape
- Heading tape
- Vertical Speed Indiator
- G-meter with peak memory
- Slip indicator
- Turn rate indicator
- Bugs may be set for heading and altitude
- 3 video inputs for color cameras (video format: PAL composite)
- GPS receiver included
- Intercom audio out
- Software upgradable by means of SD card
- Data logger with integrated graphic data viewer
ALARMS:
- Engine alarms are activated when the relative measurement is out of range, they can be both displayed and on the audio out tone or vocal alert.
- Fuel alarms for (fuel flow, endurance, remaining fuel, burned fuel, range and reserve at destination). It's possible to activate 3 alarms for the remaining fuel, time to empty and for balancing tanks.
When a measure drops below its setpoint the alarm is activated on both display and/or audio out tone or vocal alert.
Technical specifications:
Dimensions: 196 x 139 x 60 mm
Weight: 900 g
Operating temperature range: -20~+70 °C
Supply voltage: 12~15 Vdc
Supply current: 1 A
Electrical connections using D-Sub connectors
Software upgradable by means of SD card
The following wiring and probes are available
- Cod. 601008 EGT probe with 2.5 m cable + coupling to weld - Cod. 601012 Pre-wired cable for EGT probes - Cod. 601020 OAT probe (Outside air temp.) with 2.5 m cable - Cod. 601030 CAT probe (Carburetor/airbox air temp.), 10x1 thread and 2.5 m cable - Cod. 503030 RedCube Fuel Flow transducer - Cod. 601041 Fuel pressure transducer with 2.0 m cable + fitting - Cod. 601060 Ammeter probe +/- 50 A - Cod. 601061 Ammeter probe +/- 100 A - Cod. 602000 Oil pressure probe, Rotax 4-20mA compatible, with 1/8" NPT male thread - Cod. 603000 Professional crimping tool - Cod. 703010 SD Card 2GB for ECLIPSE
